Step 1
Prepare gluing
Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.
MagCharge
Volkswagen Crafter 2.1
The main steps for installing your new mobile phone holder are described below. We start with the installation of the inductive holder itself and then ensure a clean look in your cockpit with our cable routing set.
Parts of this guide are not yet available in English and are shown in German.
Phone holder
Step 2
Remove protective film
Now remove the red protective film from the adhesive on the holder.
Step 3
Mount holder
Position the holder as shown in the illustration and secure it by applying pressure.
Cable routing
Option 2: Untere USB-Dose/Zigarettenanzünder
Es gibt die zwei Optionen die Kabelführung einzubauen - zum einen zur oberen USB-Dose oder zur unteren USB-Dose/Zigarettenanzünder. Bei der MagCharge ist immer Option 2 zu wählen.
Step 1
Prepare gluing
Clean the adhesive area with the cleaning cloth, wait one minute before continuing.
Step 2
Cable in position
Place the cable in the position shown in the illustration and plug it into the USB socket.
Step 3
Prepare gluing
Remove the red protective film from the adhesive tape on the cable guide.
Step 4
Gluing
Install the cable guide at the marked position.
Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.
Was this guide helpful?
Thanks for your feedback!
Frequently asked questions
See all questions →How do I adjust the bracket correctly? It keeps slipping.
Tighten the two central adjustment screws slightly. This makes it harder for the cheeks to move and the adjustment is easier.
The cheeks cannot be pulled out. What to do?
Make sure that all six screws are loosened.
You can finely adjust the pressure on the cheeks with the two centre adjustment screws.
The adhesive test does not work, the bracket does not hold.
Some cleaning and cockpit sprays contain silicone, which prevents adhesion.
Use a special degreasing silicone cleaner and repeat the application several times until the bonding works on this surface.
I have broken a part or need a different cable for my new mobile phone
No problem! We offer spare parts such as cables, adhesives and other components separately.
Just send us an e-mail to info@beevention.com.
My mobile phone is charging too slowly or the car battery is flat. What can I do?
VW often uses charging sockets with low charging power. Use the cigarette lighter with a suitable adapter instead.
Attention: The cigarette lighter does not switch off automatically when the car is switched off. It is best to pull out the plug after use to avoid a flat battery.
Any questions?
We are happy to help – just drop us a line.