Phone won't hold or charge with a case
On some cases the frame around the camera is so large that it reaches onto the holder's magnet. The phone then sits at an angle: it holds less firmly and the MagCharge does not charge. Here you can see why, how to check your case and which cases fit.
- Magnet area of the holder
- Camera frame of the case
- Overlap and gap
- Schematic, not to scale
Why does this happen?
On the back of your iPhone there is a ring of magnets (MagSafe, the same with the Qi2 standard). The holder's magnet sits exactly on it. For the phone to hold firmly and charge, both have to lie flat against each other with no gap.
Many cases have a raised protective frame around the camera. If it is much larger than the camera itself, it reaches into the magnet area. The phone then rests on the camera frame instead of the magnet:
- The magnet has to pull across a gap. The phone holds less firmly and can slip while driving.
- Wireless charging needs direct contact. With a gap, the MagCharge does not start charging or keeps stopping.
- Without the case, everything works perfectly.
Why is our magnet so big?
We fit the magnet at the full size of the MagSafe ring, with less than 1 mm of edge. More magnet area means more grip: your phone stays securely in place on cobblestones, when braking and in corners.
Other chargers often have a smaller contact surface. The same case may work there, but the phone holds less firmly.
How to check your case
- Test without the case. Put your phone on the holder without its case. If it holds firmly and charges, the case is the cause.
- Look from the side. Put the phone on with its case. If it does not lie completely flat or rocks when you press a corner, the camera frame is in the way.
- Look at the back. On many MagSafe cases the magnet circle is visible on the back. The raised camera frame must not reach into this circle and needs at least 1 mm of clearance all around.
- Not charging without the case either? Then the camera frame is not the cause. First check that the MagCharge is plugged into the included 12 V charger in the cigarette lighter. The vehicle's USB sockets usually do not deliver enough power for it.
- MagLine: on delivery a white magnet ring sits on the holder. For iPhone 12 and later and for MagSafe cases it has to come off, otherwise the gap is too large.
Which case fits?
Fits
- MagSafe or Qi2 case with built-in magnets
- slim camera frame that sits tight around the camera
- flat back around the magnet
- thin case
Does not fit
- wide camera frame or a camera plate reaching far towards the centre
- camera slider, ring or stand at the camera
- card slot, grip or ring on the back
- thick rugged cases
What does not help
- Placing the phone lower or to the side: the magnet keeps pulling it back to the centre.
- Spacer rings, shims or an extra magnet ring: they increase the gap. On the MagCharge, metal and magnet rings also interfere with charging.
Not sure whether your case fits?
Send us a photo of the back of your case and one from the side with the phone on the holder. We will tell you whether it fits.