Step 1
VW receiver
The holder is inserted into the existing VW receiver 813 847 on the dashboard, without any gluing.
The following are the essential steps for installing your new phone holder. We will start with installing the holder itself and then use our cable management kit to give your cockpit a clean look.
Step 1
The holder is inserted into the existing VW receiver 813 847 on the dashboard, without any gluing.
Step 2
Press the plug of the charging cable into the plug seat at the bottom of the holder so that it points upwards.
Step 3
Insert the holder into the VW receiver.
Step 4
Press the holder into the receiver and close the upper jaw until everything sits firmly.
Step 1
Fix the mobile phone holder to the vehicle adapter, tighten the screws only slightly.
Step 2
Pull the cheeks of the mobile phone holder apart.
Step 3
Insert mobile phone.
Step 4
Press the cheeks against the mobile phone and carefully remove the mobile phone.
Step 5
Tighten all 6 screws of the mobile phone holder.
Step 1
Clean the adhesive area with the cleaning cloth, wait one minute before continuing.
Step 2
Place the cable in the position shown in the illustration and plug it into the USB socket.
Step 3
Remove the red protective film from the adhesive tape on the cable guide.
Step 4
Install the cable guide at the marked position.
Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.
Thanks for your feedback!
Tighten the two central adjustment screws slightly. This makes it harder for the cheeks to move and the adjustment is easier.
Make sure that all six screws are loosened.
You can finely adjust the pressure on the cheeks with the two centre adjustment screws.
Some cleaning and cockpit sprays contain silicone, which prevents adhesion.
Use a special degreasing silicone cleaner and repeat the application several times until the bonding works on this surface.
No problem! We offer spare parts such as cables, adhesives and other components separately.
Just send us an e-mail to info@beevention.com.
VW often uses charging sockets with low charging power. Use the cigarette lighter with a suitable adapter instead.
Attention: The cigarette lighter does not switch off automatically when the car is switched off. It is best to pull out the plug after use to avoid a flat battery.
We are happy to help – just drop us a line.
Nothing found. Try the model or the manufacturer.