beev.manual
BaseLine

Volkswagen Aufnahmehalter 813 847

10 steps 2 chapters

Below you will find the essential steps for installing your new BaseLine phone holder. It is inserted into the VW receiver 813 847 without any gluing. Finally, the cable routing set gives your cockpit a clean look.

1

Holder

Step 1

VW receiver

The BaseLine is inserted into the existing VW receiver 813 847 on the dashboard, without any gluing.

Step 2

Insert charging cable

Place the charging cable in the slot on the underside of the holder.

Step 3

Insert holder

Insert the BaseLine into the VW receiver from above.

Step 4

Close the receiver

Press the upper jaw of the receiver until it holds the holder firmly.

Step 5

Insert phone

Pull the side arms apart, insert your phone and let go of the arms.

Step 6

Connect power

Plug the charging cable into a USB socket or a USB adapter in your vehicle.

2

Cable routing

Step 1

Prepare gluing

Clean the adhesive area with a clean cloth so that it is free of dust and grease. Wait one minute before continuing.

Step 2

Cable in position

Place the cable in the position shown in the illustration and plug it into the USB socket.

Step 3

Remove protective film

Remove the red protective film from the adhesive tape on the cable guide.

Step 4

Gluing

Install the cable guide at the marked position.

Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.

Frequently asked questions

See all questions →
How do I adjust the bracket correctly? It keeps slipping.

Tighten the two central adjustment screws slightly. This makes it harder for the cheeks to move and the adjustment is easier.

The cheeks cannot be pulled out. What to do?

Make sure that all six screws are loosened.

You can finely adjust the pressure on the cheeks with the two centre adjustment screws.

The adhesive test does not work, the bracket does not hold.

Some cleaning and cockpit sprays contain silicone, which prevents adhesion.

Use a special degreasing silicone cleaner and repeat the application several times until the bonding works on this surface.

I have broken a part or need a different cable for my new mobile phone

No problem! We offer spare parts such as cables, adhesives and other components separately.

Just send us an e-mail to info@beevention.com.

My mobile phone is charging too slowly or the car battery is flat. What can I do?

VW often uses charging sockets with low charging power. Use the cigarette lighter with a suitable adapter instead.

Attention: The cigarette lighter does not switch off automatically when the car is switched off. It is best to pull out the plug after use to avoid a flat battery.

Any questions?

We are happy to help – just drop us a line.

Send an e-mail