MANUAL.

Bh vw-c2 ml/en: Unterschied zwischen den Versionen

← Zum vorherigen VersionsunterschiedZum nächsten Versionsunterschied →
VisuellWikitext
Die Seite wurde neu angelegt: „'''3. Kabel einsetzen'''“
Die Seite wurde neu angelegt: „* Insert the charging cable into the holder as shown in the illustration.“
Zeile 27: Zeile 27:
'''3. Kabel einsetzen'''
'''3. Kabel einsetzen'''
</div>
</div>
<div lang="de" dir="ltr" class="mw-content-ltr">
* Insert the charging cable into the holder as shown in the illustration.
* Setze das Ladekabel entsprechend der Abbildung in die Halterung ein.
</div>
</div>
</div>


Version vom 8. August 2025, 19:31 Uhr

INSTRUCTIONS.

The following are the essential steps for installing your new phone holder. We will start with installing the holder itself and then use our cable management kit to give your cockpit a clean look.

1. cell phone holder

1. prepare bonding

  • Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.

2. remove protective film

  • Now remove the red protective film from the adhesive on the holder.

3. Kabel einsetzen

  • Insert the charging cable into the holder as shown in the illustration.

3. mount the holder

  • Position the holder as shown in the illustration and secure it by applying pressure.


2. cable routing

1. prepare bonding

  • Clean the adhesive area with the cleaning cloth, wait one minute before continuing.

2. cable in position

  • Place the cable in the position shown in the illustration and plug it into the USB socket.

3. prepare bonding

  • Remove the red protective film from the adhesive tape on the cable guide.

4. gluing

  • Install the cable guide at the marked position.

Notes

Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.

Abgerufen von „https://manual.beev.info/index.php?title=Bh_vw-c2_ml/en&oldid=777“