Diese Seite ist eine übersetzte Version der Seite Bh vw-t61 sl und die Übersetzung ist zu 100 % abgeschlossen sowie aktuell.

INSTRUCTIONS.

The following are the essential steps for installing your new phone holder. We will start with installing the holder itself and then use our cable management kit to give your cockpit a clean look.

1. Vehicle adapter

1. Prepare gluing

Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.

2. Remove protective film

Now remove the red protective film from the adhesive on the holder.

3. Insert Cable

Insert the charging cable into the holder as shown in the illustration.

4. Mount holder

Position the holder as shown in the illustration and secure it by applying pressure.

2. Mobile phone holder

Pre-assembly

Fix the mobile phone holder to the vehicle adapter, tighten the screws only slightly.

Open cheeks

Pull the cheeks of the mobile phone holder apart.

Insert mobile phone

Insert mobile phone.

Close cheeks

Press the cheeks against the mobile phone and carefully remove the mobile phone.

Fix cheeks

Tighten all 6 screws of the mobile phone holder.

3. Cable routing

1. Kleben vorbereiten

Reinige die Klebestelle mit dem Reinigungstuch, warte eine Minute bevor du weiter machst.
Clean the adhesive area with the cleaning cloth, wait one minute before continuing.

2. Kabel in Postion

Lege das Kabel in Postion entsprechend der Abbildung und Stecke es in die USB-Dose.
Place the cable in the position shown in the illustration and plug it into the USB socket.

3. Kleben vorbereiten

Entferne die rote Schutzfolie vom Klebeband der Kabelführung.
Remove the red protective film from the adhesive tape on the cable guide.

4. Kleben

Installiere die Kabelführung an der markierten Stelle.
Install the cable guide at the marked position.

Notes

Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.