INSTRUCTION.
The main steps for installing your new mobile phone holder are described below. We start with the installation of the inductive holder itself and then ensure a clean look in your cockpit with our cable routing set.
1. Handyhalter | phone holder
1. prepare bonding
- Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.
2. remove protective film
- Now remove the red protective film from the adhesive on the holder.
3. Halter montieren
- Postioniere den Halter entsprechend der Abbildung und fixiere ihn durch Druck.
2. Kabelführungs-Set | cable routing set
1. Kleben vorbereiten
- Reinige die Klebestelle mit dem Reinigungstuch, warte eine Minute bevor du weiter machst.
- Clean the adhesive area with the cleaning cloth, wait one minute before continuing.
2. Kabel in Postion
- Lege das Kabel in Postion entsprechend der Abbildung und Stecke es in die USB-Dose.
- Place the cable in the position shown in the illustration and plug it into the USB socket.
3. Kleben vorbereiten
- Entferne die rote Schutzfolie vom Klebeband der Kabelführung.
- Remove the red protective film from the adhesive tape on the cable guide.
4. Kleben
- Installiere die Kabelführung an der markierten Stelle.
- Install the cable guide at the marked position.
Important note
It is mandatory to use the enclosed 12V adapter for the cigarette lighter - unfortunately, the original charging sockets do not support USB PD 9V 3A, which the MagCharge requires.
Notes
Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.