INSTRUCTION.
The main steps for installing your new mobile phone holder are described below. We start with the installation of the inductive holder itself and then ensure a clean look in your cockpit with our cable routing set.
1. cell phone holder
1. prepare bonding
- Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.
2. remove protective film
- Now remove the red protective film from the adhesive on the holder.
3. Monter le support
- Positionne le support comme indiqué sur l'illustration et fixe-le en appuyant dessus.
2. cable routing
1. prepare bonding
- Clean the adhesive area with the cleaning cloth, wait one minute before continuing.
2. cable in position
- Place the cable in the position shown in the illustration and plug it into the USB socket.
3. prepare bonding
- Remove the red protective film from the adhesive tape on the cable guide.
4. gluing
- Install the cable guide at the marked position.
Important note
It is mandatory to use the enclosed 12V adapter for the cigarette lighter - unfortunately, the original charging sockets do not support USB PD 9V 3A, which the MagCharge requires.
Notes
Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.