Aktuelle Version vom 8. August 2025, 19:26 Uhr

INSTRUCTION.

The main steps for installing your new mobile phone holder are described below. We start with the installation of the inductive holder itself and then ensure a clean look in your cockpit with our cable routing set.

1. cell phone holder

1. prepare bonding

Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.

2. remove protective film

Now remove the red protective film from the adhesive on the holder.

3. Monter le support

Positionne le support comme indiqué sur l'illustration et fixe-le en appuyant dessus.

2. cable routing

1. prepare bonding

Clean the adhesive area with the cleaning cloth, wait one minute before continuing.

2. cable in position

Place the cable in the position shown in the illustration and plug it into the USB socket.

3. prepare bonding

Remove the red protective film from the adhesive tape on the cable guide.

4. gluing

Install the cable guide at the marked position.

Important note

It is mandatory to use the enclosed 12V adapter for the cigarette lighter - unfortunately, the original charging sockets do not support USB PD 9V 3A, which the MagCharge requires.

Notes

Frequently asked questions can be found in my Q&A, for all other questions please contact us by email info@beevention.com.

@@ Zeile 7: / Zeile 7: @@
 <div style="display: inline-block; text-align: center; max-width: 360px; word-wrap: break-word; white-space: normal;">
-{{#invoke:BoxModul|fotobox|bh_vw-c2_mc_pic-000.png|360}}
+{{#invoke:BoxModul|fotobox|bh_vw-c2_sl_pic-000.png|360}}
 <div>
 '''1. prepare bonding'''
@@ Zeile 31: / Zeile 31: @@
 </div>

Bh vw-c2 mc/en: Unterschied zwischen den Versionen