Bh cr describe/en: Unterschied zwischen den Versionen
Die Seite wurde neu angelegt: „Cable in position“ |
Übernehme Bearbeitung einer neuen Version der Quellseite |
||
| Zeile 1: | Zeile 1: | ||
<!-- 1. Kleben vorbereiten --> | <!-- 1. Kleben vorbereiten --> | ||
<section begin="prepare_gluing_title"/>Prepare gluing<section end="prepare_gluing_title"/> | <section begin="prepare_gluing_title"/>Prepare gluing<section end="prepare_gluing_title"/> | ||
<section begin="prepare_gluing_text"/>* Clean the adhesive area with the cleaning cloth, wait one minute before continuing.<section end="prepare_gluing_text"/> | <section begin="prepare_gluing_text"/>* Clean the adhesive area with the cleaning cloth, wait one minute before continuing.<section end="prepare_gluing_text"/> | ||
<!-- 2. Kabel in Position --> | <!-- 2. Kabel in Position --> | ||
<section begin="cable_position_title"/>Cable in position<section end=" | <section begin="cable_position_title"/><span class="mw-translate-fuzzy">Cable in position</span><section end="cable_position_title"/> | ||
<section begin="cable_position_text"/>* Place the cable in the position shown in the illustration and plug it into the USB socket.<section end=" | <section begin="cable_position_text"/><span class="mw-translate-fuzzy">* Place the cable in the position shown in the illustration and plug it into the USB socket.</span><section end="cable_position_text"/> | ||
<!-- 3. Kleben vorbereiten --> | <!-- 3. Kleben vorbereiten --> | ||
<section begin="remove_tape_title"/>Prepare gluing<section end=" | <section begin="remove_tape_title"/>Prepare gluing<section end="remove_tape_title"/> | ||
<section begin="remove_tape_text"/>* Remove the red protective film from the adhesive tape on the cable guide.<section end=" | <section begin="remove_tape_text"/>* Remove the red protective film from the adhesive tape on the cable guide.<section end="remove_tape_text"/> | ||
<!-- 4. Kleben --> | <!-- 4. Kleben --> | ||
<section begin="gluing_title"/>Gluing<section end=" | <section begin="gluing_title"/>Gluing<section end="gluing_title"/> | ||
<section begin="gluing_text"/>* Install the cable guide at the marked position.<section end=" | <section begin="gluing_text"/>* Install the cable guide at the marked position.<section end="gluing_text"/> | ||
Aktuelle Version vom 10. August 2025, 12:04 Uhr
Prepare gluing
- Clean the adhesive area with the cleaning cloth, wait one minute before continuing.
Cable in position * Place the cable in the position shown in the illustration and plug it into the USB socket.
Prepare gluing
- Remove the red protective film from the adhesive tape on the cable guide.
Gluing
- Install the cable guide at the marked position.