Bh vw-c2 cr/en: Unterschied zwischen den Versionen
Die Seite wurde neu angelegt: „'''3. prepare bonding'''“ |
Die Seite wurde neu angelegt: „* Install the cable guide at the marked position.“ |
||
| (2 dazwischenliegende Versionen desselben Benutzers werden nicht angezeigt) | |||
| Zeile 22: | Zeile 22: | ||
'''3. prepare bonding''' | '''3. prepare bonding''' | ||
</div> | </div> | ||
* Remove the red protective film from the adhesive tape on the cable guide. | |||
* | |||
</div> | </div> | ||
| Zeile 30: | Zeile 28: | ||
{{#invoke:BoxModul|fotobox|bh_vw-c2_cr_pic-003.png|360}} | {{#invoke:BoxModul|fotobox|bh_vw-c2_cr_pic-003.png|360}} | ||
<div> | <div> | ||
'''4. gluing''' | |||
'''4. | |||
</div> | </div> | ||
* Install the cable guide at the marked position. | |||
</div> | </div> | ||
</div> | </div> | ||
Aktuelle Version vom 8. August 2025, 17:51 Uhr
1. prepare bonding
- Clean the adhesive area with the cleaning cloth, wait one minute before continuing.
2. cable in position
- Place the cable in the position shown in the illustration and plug it into the USB socket.
3. prepare bonding
- Remove the red protective film from the adhesive tape on the cable guide.
4. gluing
- Install the cable guide at the marked position.