Bh mc describe/en: Unterschied zwischen den Versionen
Die Seite wurde neu angelegt: „Prepare gluing“ |
Übernehme Bearbeitung einer neuen Version der Quellseite |
||
| Zeile 7: | Zeile 7: | ||
<section begin="remove_protective_film_text"/>* Now remove the red protective film from the adhesive on the holder.<section end="remove_protective_film_text"/> | <section begin="remove_protective_film_text"/>* Now remove the red protective film from the adhesive on the holder.<section end="remove_protective_film_text"/> | ||
<!-- 3 | <!-- 3. Halter montieren --> | ||
<section begin="holder_mount_title"/>Mount holder<section end="holder_mount_title"/> | <section begin="holder_mount_title"/>Mount holder<section end="holder_mount_title"/> | ||
<section begin="holder_mount_text"/>* Position the holder as shown in the illustration and secure it by applying pressure.<section end="holder_mount_text"/> | <section begin="holder_mount_text"/>* Position the holder as shown in the illustration and secure it by applying pressure.<section end="holder_mount_text"/> | ||
Aktuelle Version vom 20. Januar 2026, 12:21 Uhr
Prepare gluing
- Clean the adhesive surface with an alcohol wipe and test the adhesive effect using the enclosed TEST adhesive. If it does not hold, clean further, see our Q&A.
Remove protective film
- Now remove the red protective film from the adhesive on the holder.
Mount holder
- Position the holder as shown in the illustration and secure it by applying pressure.